How do I wire-up and configure a surround sound system?

Surround System Wiring and Configuration

We recommend running the audio signal cables first to the subwoofer(s) and from there to the monitors. When the subwoofer has less inputs and outputs than the number of monitors, the usual choice is to run the front monitors via the subwoofer and connect the surround or height monitors directly to the sound source. In this case, the subwoofer will only aid the front monitors in low frequency reproduction.

When the Smart Active Monitoring (SAM) uses distributed bass management the audio signals can be routed in any order to subwoofers and monitors. The bass management settings will be accomplished in the Genelec Loudspeaker Manager (GLM) software during the setup. The important aspect is that the same audio signal must run to the monitors and subwoofers for all the monitors that need subwoofer support.

Previous
Next
360013342560

Was this article helpful?

6 out of 10 found this helpful

Contact Us

Submit a request
Let us know the details of your request
Chat with us via widget
Available weekdays - 7am to 3pm GMT+2 /(DST+3)